Embedded Studio Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Warning message after converting project of v4.5 to v5.0

2 posters

Go down

Warning message after converting project of v4.5 to v5.0 Empty Warning message after converting project of v4.5 to v5.0

Post  GoldenMaple Fri Aug 22, 2008 6:38 pm

Dear Sir/Madam:

After upgrading VisualDSP++ from v4.5 to v5.0 with Update 3, I converted my project that was built with v4.5 to v5.0, every time after building, there was a warning message something like

Trying to load an executable built for 0.0 silicon to a 0.1 silicon target. Continue? Yes (button) or No (button)

Even though it is not a big deal but do you know how to eliminate that message? Thanks a lot.


Last edited by GoldenMaple on Mon Aug 25, 2008 10:12 am; edited 1 time in total

GoldenMaple

Posts : 11
Join date : 2008-08-22

Back to top Go down

Warning message after converting project of v4.5 to v5.0 Empty Re: Warning message after converting project of v4.5 to v5.0

Post  lzmind Fri Aug 22, 2008 6:42 pm

Under Project->Project Options can you please make sure that the "Revision" setting is 0.1? Or you can set the revision to automatic. The error message indicates that 0.0 silicon revision has been currently chosen. By changing the "revision" to 0.1 should stop this message appearing.

Please reply if it helps.


Last edited by lzmind on Fri Aug 22, 2008 7:28 pm; edited 1 time in total

lzmind

Posts : 18
Join date : 2008-08-20

Back to top Go down

Warning message after converting project of v4.5 to v5.0 Empty Re: Warning message after converting project of v4.5 to v5.0

Post  GoldenMaple Fri Aug 22, 2008 7:25 pm

Thanks for your support. That worked.

Interestingly, however, the revision selection was automatic. After I selected 0.1 for dsp revision, the warning message was eliminated. Then I changed it to automatic again, the message did not appear any more. I bet that the revision was reset to 0.0 after converting, and the selection was not reflected in Project Option window.

It was good to discuss issues with professionals like you, lzmind. Thanks.

GoldenMaple

Posts : 11
Join date : 2008-08-22

Back to top Go down

Warning message after converting project of v4.5 to v5.0 Empty Re: Warning message after converting project of v4.5 to v5.0

Post  Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum